15
english
Jabra PrO 9460, 9460-DuO, 9465-DuO anD 9470 user manual
the Quick-StaRt SetuP wizaRd
4.2
to get started, just power the base and then follow the set-up-wizard instructions on the touchscreen.
to run the setup wizard:
1. review the information outlined in
Section 4.1: Setup Overview and Background
. It will help you understand the
types of tasks that the setup wizard will ask you to do.
2. assemble the base and apply power to it. (see also
Section 4.3: Preparing the base and and Assembling the
Headset)
.
3. the base automatically launches the setup wizard the first time you turn it on. On each page of the wizard,
follow the instructions shown and then touch the “next” icon (see also
Section 8.2: Using the Touchscreen
).
-
Note:
when the wizard is helping you set up your desk phone, it will ask you to call the Jabra test server.
this enables the base to test its clear dial-tone switch and mic.-level settings by exchanging signals with
the test server. see your Jabra PrO Quick start guide for a list of Jabra test-server phone numbers (also
available on our web site). If, for some reason, the connection to the test server fails, you are prompted to
retry; you can retry the automatic setup or try a manual setup. you can also choose to retry the cable setup.
4. Continue until the wizard tells you that you are finished. at this point, all of your phones should be connected
and your headset will be fully configured to work with each of them.
the remainder of this chapter provides extra information about each step of the setup process. refer to this
chapter if you have trouble while working through the on-screen setup wizard.
Tip:
you can re-start the setup wizard manually at any time, thereby re-initializing some or all base and
headset settings. see
Section 8.9: Re-running the Setup Wizards
for details.
PRePaRing the BaSe and and aSSeMBling the headSet
4.3
Adjusting the Headset Cradle
the headset cradle is already attached to the Jabra PrO base when it is delivered but you might want to adjust its
angle in order to optimize for left- or right-handed docking. to do this, simply rotate the cradle until it sits at your
preferred docking angle. as you rotate the cradle, you will feel it fit into a number of distinct positions on the
base. the figure below shows the angular range; -90 to +45 degrees.
-90
45
Figure 8: Adjusting the headset cradle angle on the base
If, at a later stage, you need to remove the cradle (for example to replace it with another), simply rotate the cradle
clockwise as far as possible, then carefully pull it out from the base.
to attach / re-attach a headset cradle on the base, hold the cradle against the base so that the large and small
pins on either side of the cradle post align with the matching slots on either side of the hole on the base. then
simply push it into the base.
