22
english
Jabra PrO 9460, 9460-DuO, 9465-DuO anD 9470 user manual
1. If you have not already done so, then set the clear dial-tone switch as described above.
2. the touchscreen wizard prompts you to call the Jabra test server. follow the on-screen instructions. the base
will determine the optimal microphone level automatically.
for Jabra PrO 9465-Duo / 9470, the base already has contact with the test server from setting the clear dial-
tone switch.
If the base cannot contact the test server, you can re-try or you can try to set the mic.-level manually — see
the procedure below.
If the Jabra PRO base cannot contact the Jabra test server:
In this case, you can choose to set the mic.-level manually:
1. If you have not already done so, then set the clear dial-tone switch as described above.
2. make arrangements to call a friend who is not sitting nearby. tell your friend that you will be testing your
headset and ask him or her not to adjust his or her own telephone volume during the test.
3. Call your friend by doing the following:
- wear the headset and position its microphone close to your mouth.
- Press the headset button on your desk phone (or lift the handset) to connect to the phone network.
- Dial your friend’s number using your desk-phone buttons.
4. as you speak with your friend, adjust the mic.-level control on the Jabra PrO touchscreen (Desk phone setup
wizard, manual setup) until your friend tells you that your voice sounds clear (loud enough) but not distorted
(too loud).
MANUAL SETUP
Set microphone level
Manual mic. level selection for Jabra PRO 9465-Duo / 9470
Figure 18:
the desk phone part of the setup wizard guides you through. remind your friend not to adjust his or her own
volume during the test.
If your best mic.-level setting turns out to be the loudest possible and you found more than one best position
for the clear dial-tone switch, then move the clear dial-tone switch to the alternative setting and try again to
find the best mic.-level together with your friend. If this time the mic.-level is not set to the maximum, then
keep this new combination of settings.
5. Press the headset button on your desk phone (or replace the handset) to hang up. then dock the headset
(the audio link from the headset to your desk phone closes automatically when you dock the headset).
your headset is now ready for use.
