25
english
Jabra PrO 9460, 9460-DuO, 9465-DuO anD 9470 user manual
Connecting to a Load-detect equipped Phone
In principle, any load-detect equipped desk phone — for example toshiba and shoretel phones — requires an
electronic hookswitch adapter that uses rhl protocol. this is in contrast to the other ehs adapters which use
msh, Dhsg or Cisco protocols. It means that the ehs adapter must be set up in a similar way to the gn1000 rhl.
we strongly recommend you use the following procedure together with the desk phone setup wizard to ensure
that the ehs adapter is setup correctly.
SELECT
El. hookswitch adapter
(EHS)
GN1000 Remote Handset
lifter (RHL)
1. when you
reach the
touchscreen
shown
left, select
GN1000
Remote
Handset
Lifter (RHL)
.
CONNECT
Unplug handset cable
2. In the first
CONNECT
(unplug
handset)
touchscreen
shown left, do
nothing except
go to the next
screen.
Select GN1000 RHL for e.g. Toshiba and
Figure 21:
ShoreTel desk phone EHS adapter
Do nothing here
Figure 22:
CONNECT TO BASE
3. In the (first)
CONNECT
TO BASE
touchscreen
shown left,
do nothing
except go
to the next
screen.
CONNECT TO BASE
4. In the (second)
CONNECT
TO BASE
touchscreen
shown left,
connect the
cable with
the blue
marking to the
base port, as
indicated in
the wizard.
Do not connect as shown here
Figure 23:
Connect as shown here
Figure 24:
CONNECT DESK PHONE
5. In the
CONNECT
DESK PHONE
touchscreen
shown left,
connect to
the
headset
port and
not
the handset
port (for a
gn1000,
you would
connect to
the handset
port).
CONNECT
6. In the (second)
CONNECT
touchscreen
shown left,
connect the
ehs adapter
cable to the
base’s auX
port.
Connect, but not as shown here
Figure 25:
Connect adapter cable to AUX port on the base
Figure 26:
