26
english
Jabra PrO 9460, 9460-DuO, 9465-DuO anD 9470 user manual
7. Connect the other end of the ehs adapter cable to the adapter’s auX port:
now there is a connection between the Jabra base and adapter auX ports.
8. Connect the adapter’s ring detector cable between the desk phone’s speaker and the dedicated port on the
back of the adpater. If you are in any doubt, please refer to the 14201-20 ehs adapter documentation.
GN1000
Mount and configure
GN1000 on desk phone.
Follow the instructions in
GN1000 manual
9. In the (first)
GN1000
touchscreen
shown left,
do nothing
except go
to the next
screen.
GN1000
Did the GN1000 lift the
handset successfully?
Yes
No
10. In the (second)
GN1000
touchscreen
shown left,
you must
determine
whether the
desk phone
went off-hook.
If so, touch
Yes
. Consult
the shoretel or
toshiba desk
phone manual
if you are
unsure.
Do nothing here
Figure 27:
Touch
Figure 28:
Yes
if the desk phone went off-hook
If the phone did not go off-hook, touch
No
. In this case, you can choose to
Retry
or
Cancel
. If you choose to retry,
the touchscreen takes you back to a point in this flow just after step1 (where the gn1000 has been selected). If
you choose to cancel, the setup is aborted and the touchscreen takes you to the start of the cabling procedure
for configuration without rhl or ehs. you can return to the rhl setup later.
GN1000
Check GN1000 manual to
adjust ring detector
11. In the (third)
GN1000
touchscreen
shown left,
you do not
need to do
anything as
the ehs ring
detector is
adjusted
automatically.
Just go to the
next screen.
GN1000
Congratulations, GN1000
installation complete
12. the (fourth)
GN1000
touchscreen
shown left
lets you know
that the setup
is completed
successfully.
Just go to the
next screen.
Do nothing here
Figure 29:
A successful setup
Figure 30:
the wizard now leads you through the clear-dial tone and mic. level configuration. see the section “Configuring
the Jabra PrO base for your Desk Phone” for more.
Connecting to a Phone using RHL Mode
In the case of a phone that uses rhl mode, the 14201-20 ehs adapter is not used. follow the the procedure given
in the previous section (“Connecting to a load-detect equipped Phone”) up to and including step 7. from step 8.
however, just connect and follow the wizard instructions in the same way as for a gn1000 rhl.
