35
english
Jabra PrO 9460, 9460-DuO, 9465-DuO anD 9470 user manual
to terminate the current call when no calls are on hold, do one of the following:
- For desk phones without a handset lifter or electronic-hookswitch:
Place the desk phone handset back onto its receiver or press the desk-phone headset button (if present) to
terminate the call. then close the audio link to the headset by doing one of the following:
tap
the headset
multifunction button, touch the end-call icon on the base touchscreen, or dock the headset to the base.
- For all other types of phones:
Tap
the headset multifunction button, touch the end-call icon on the base touchscreen, or dock the headset
to the base.
contRolling the SPeakeR voluMe and MicRoPhone
6.6
the headset features a touch panel that is similar to the touch pad included with many laptop computers. use it
to adjust the volume you hear in your headset and to mute/enable the microphone.
- slide your finger up the touch panel (away from your mouth) to increase the volume.
- slide your finger down the touch panel to decrease the volume.
- Double-tap on the touch panel to mute or unmute the microphone.
2 x
Figure 43: Use the headset’s touch panel to control listening volume and microphone mute
you can also control the volume and mute functions using the touchscreen; see
Section 8.5: Setting Active-Call and
Audio Preferences
for details.
Note:
a tone will sound to indicate each new volume setting; a double tone indicates that you have
reached maximum or minimum volume. you will also hear a soft tone in the headset to remind you when
microphone muting is active; this signal will repeat occasionally until you reactivate the microphone.
If you hang up while the microphone is muted, it will automatically be re-enabled the next time you
place or answer a call.
Switching Between youR Phone and headSet
6.7
It is possible to enable or disable the headset without interrupting your current call.
Desk Phones
to go from desk-phone handset to your headset:
1. If necessary, set the desk phone as the current target for your headset (see also
Section 6.2: The Target Phone
Concept.
)
2. Open the audio link to the headset by doing one of the following:
tap
the headset’s multifunction button;
touch the call icon on the base touchscreen; or lift the headset from the base (if enabled, see
Section 8.13:
Headset Docking-Operation
).
3. listen to hear if you are now connected through the headset. If you are not connected, then you may need to
press the desk-phone headset button. see also your desk-phone documentation.
4. Place the handset on your desk, but do not hang up, because this will terminate your call.
