45
english
Jabra PrO 9460, 9460-DuO, 9465-DuO anD 9470 user manual
BatteRy indicatoRS, RechaRge and RePlaceMent
7.4
Battery indicators
the headset and touchscreen base indicate the current headset battery level as follows:
- whenever the battery is low, the headset multicolor leD will display red for all of its usual signals.
- while the battery is low, you will hear an audio signal (two quick, low tones) every minute or so in the
headset.
- when the headset is paired with a touchscreen base, you can read the current battery level on the
touchscreen.
Recharging the Headset
to recharge your headset battery, place the headset in its cradle on the base. see also
Section 4.3: Preparing the
base and Assembling the Headset.
How to replace the battery
If you begin to notice that you get significantly less talk time between battery charges, it might be time to replace
the battery.
to replace the headset battery:
1. Order a Jabra PrO battery-replacement kit from Jabra (contact your Jabra representative or see our web site
for details).
2. remove the wearing-style attachment from your headset (see also
Section 7.2: Attaching or detaching a
Wearing Style
).
3. Place the headset down on a table with the speaker facing up.
4. use the screwdriver supplied with the battery-replacement kit to remove the three screws indicated in the
figure below.
5. Carefully tilt the speaker plate up, allowing it to rotate around the edge where the boom arm sticks out.
6. the battery is the rectangular component now visible in the center of the headset body. gently pry the battery
up and out of the headset. the battery will remain attached to the headset by a pair of very thin wires.
