54
english
Jabra PrO 9460, 9460-DuO, 9465-DuO anD 9470 user manual
If you have an active call, with no calls waiting, and you then put the active call on hold, the red (end call) button
is removed from display. this means that you must re-activate the held call before you can end it (press the green
arrow). see the figure below:
The current (active) call is put on hold; no other calls are waiting
Figure 57:
Note:
call waiting is not the same as call collision, which is what happens when you are talking on one
phone (e.g., your desk phone) and a new call comes in on another phone (e.g., your mobile phone). see
Section 8.6: Managing Call Collision
for details about how this is handled.
Note:
if call waiting is active when a call collision occurs, then the touchscreen will indicate the collision
and enable you either to ignore the incoming call or to answer it, thus dropping all of the active and held
calls being managed by call waiting. the headset, however, does not provide a tone to inform you of a call
collision if you have held calls; it essentially ignores the colliding call until there are no more calls on hold.
Setting geneRal uSeR PRefeRenceS
8.8
when you are not using the headset, you are able to access the general user preferences on the base. use this
function to adjust your hearing-protection settings, switch to wideband or narrowband audio, control call
recording, set the screen language, disconnect the headset or re-start some or all of the setup wizard.
settIngs
Personal setup
enable recording
Disable audio
detection
Figure 58: Finding the general user preferences
