55
english
Jabra PrO 9460, 9460-DuO, 9465-DuO anD 9470 user manual
1. wait until you have no active calls and will not need the phone for a few minutes.
2. touch the
icon in the upper-right corner of the touchscreen (available only when all connected phones
are idle).
3. the
Settings
menu opens. select one of the following:
- Personal setup:
touch here to adjust display brightness, dimming timeout, set base-speaker volume for your
desk-, mobile-, and softphone ringtones, adjust touch click-volume and to select tone or voice tags.
- Enable / Disable recording:
Determines whether audio from your desk phone and mobile phone calls are
copied to the PC for recording. the equivalent setting is available in the audio tab for your Jabra device in
Jabra Control Center. note that the recording feature is disabled by default. see also
Chapter 10: Recording
Your Calls
for more on this feature.
-
Disable / Enable audio detection:
Determines whether the audio link opens automatically when sound is
detected on the usb interface. the equivalent setting is available in the audio tab for your Jabra device in
Jabra Control Center. audio detection is enabled by default.
- Wideband audio:
touch here to view/change the band settings for softphone and deskphone (they are set
independently of each other). If wideband is enabled, the Jabra PrO base transmits and receives wideband
audio to/from the headset. see also
Section 8.11: Narrowband vs. Wideband Audio
for details about this feature.
- IntelliTone:
touch here to go to the settings for protecting your hearing. see also
Section 2.2: Protecting your
Hearing with SafeTone™
for complete details about this feature.
- Language:
touch here to change the language displayed for the touchscreen text.
- Advanced:
touch here to run some or all of the setup wizard for configuring the connection from the base to
your desk phone, mobile phone and/or computer. see also
Section 8.9: Re-running the Setup Wizards.
- About:
touch here to view a few technical details about the base, such as firmware revision, copyright details, etc.
4. follow the instructions on your screen for the option you selected.
Re-Running the SetuP wizaRdS
8.9
the very first time you turn on the base, a setup wizard launches automatically, helping you to configure the
connection to your desk phone, mobile phone and/or computer. thereafter, the base starts normally each time
your turn it on. however, if you would like to revisit your desk-phone, computer and/or mobile-phone setup, you
can do so at any time. In each case, an on-screen wizard will help you make the relevant settings.
settIngs
language
advanced
about
aDvanCeD settIngs
setup wizard
reset Configuration
setup Desk Phone
Figure 59: Finding the setup wizards
