MODELS:
23680-4003 12V DC
23680-4103 24V DC
COMMERCIAL DUTY
WATER
PUPPY
FEATURES:
Continuous rated, medium duty pumps for
bilge and general purpose use.
z
ISO 8846 MARINE (Ignition protection).
z
ISO 8849 MARINE (Bilge pump standard).
z
Small
bilge debris present no problem to
these bronze bodied, flexible impeller
pumps.
z
Simple design means fewer wearing
parts.
z
32 lpm (6.5 UK gpm) output @ 3m (10ft)
head.
z
Self priming to 1.2m (4 ft).
INSTALLATION INSTRUCTIONS
:
Jabsco Water Puppy can be mounted on any flat
surface. Fit the pump in a dry, well ventilated
position where there is full access for service. If
installed in a vertical position the motor must be
above the pump head. Use the rubber grommets
provided to minimise vibration, do not overtighten the
mounting screws.
Secure 25mm (1”) id hose either direct to the
discharge ports or to ½” BSP male threaded fittings
using stainless steel hose clamps. Use spiral
reinforced hose (with a smooth internal bore) that will
not collapse under suction, or rigid or semi rigid
pipework systems. The pipework must be compatible
with the liquid being pumped. Pipe runs should be
kept as straight and short as possible, avoiding rising
and dipping over obstructions. Fit a strainer on the
inlet hose to prevent larger debris from entering the
pump.
WIRING INSTRUCTIONS
Make all electrical connections in dry locations,
connections in humid environments should be sealed
to prevent corrosion. Protect the circuit with a
correctly rated fuse or circuit breaker in the orange
positive (+) lead as close as possible to the power
source. Connect the black motor wire to the negative
(-) battery terminal. Inadequate voltage at the motor
terminals when the pump is running (not less than
10% below rated voltage at full load) due to partially
discharged batteries or insufficient cable size may
result in blowing fuses, failure to start or poor pump
performance.
WARNING:
If the fuse fails
repeatedly do not fit a heavier fuse or
bridge the fuse terminals with silver
paper or metal wire. Failure to observe
this instruction may result in a fire
hazard due to overheating of cables.
WARNING:
All marine pumps
discharging overboard must be
installed with the overboard discharge
well above both static and heeled
waterlines.
m
ft
lpm
UK gpm
2
7
35
7.7
3
10
32
7
4
13
30
6.6
6
20
25
5.5
WATER PUPPY PERFORMANCE
TOTAL HEAD
WATER PUPPY
Approximate performance for new pump,
running water at 20°C with fully charged battery
WARNING:
Do not use any Jabsco
pump for petrol, petroleum products or
any products with a flash point below
37°C (98°F), explosion or death may
occur.
