7/9
P A A
1~9999
1
Trimming count set
P A B
0~4
0
Trimming Stitch count function mode：
0：off
1：Trimming count up, motor stop after over the setting value(use
S4 [152.INI] =CRS, or Key A to recount；
2：Trimming count down, motor stop after over the setting value(use
S4 [152.INI] =CRS, or Key A to recount；
3：Trimming count up, motor stop after over the setting value(use
S4 [152.INI] =CRS, or Key A to recount)
4：Trimming count down, motor stop after over the setting value(use
S4 [152.INI] =CRS, or Key A to recount)
3.2 Monitor mode
3.2 Monitor mode
3.2 Monitor mode
3.2 Monitor mode
No
No
No
No
Description
Description
Description
Description
No
No
No
No
Description
Description
Description
Description
0 1 0
Count needle number
0 2 5
The sampling voltage of pedal
0 1 1
Counter for sewing
pieces
0 2 6
The ratio between motor and
machine
0 1 2
The head of really
speed
0 2 7
The total used time(hours) of
motor
0 1 3
State of encoder
0 2 8
The sampling voltage of
interaction
0 2 0
DC voltage
0 2 9
Software version
0 2 1
Machine speed
0 2 A
Simulate input 2 simple value
0 2 2
The phase current
0 2 B
Simulate input 2 simple value
0 2 3
Initial electrical
angle
0 2 C
Error counting
0 2 4
Mechanical angle
0 3 0 - 0 3 7
Error code record
3.3 The warning message
3.3 The warning message
3.3 The warning message
3.3 The warning message
Alarm code
Alarm code
Alarm code
Alarm code
Description
Description
Description
Description
Corrective
Corrective
Corrective
Corrective
Count over for
stitches
The counter reaches the limit. Press P key to reset the counter.
Count over for
sewing pieces
The counter reaches the limit. Press P key to reset the counter.
Bottom line alarm Change bobbin, press P to recover
Power is off
Please wait for 30 seconds, then turn on the power switch
Safety switch
alarm
Adjust the machine to the correct position.
Summary of Contents for JK-58420B
