Speed
Keeping press then press , will be displayed “Pd-0000”, press
enter “P62-2101”, press to confirm.
Parameter
code
P00
P01
P02
P03
P05
P10
P11
P12
Default
200
3500
3000
3000
250
1800
1800
1800
Parameter
definition
Beginning sewing speed
Sewing speed
Fixed-length
sewing speed
Manual reinfored
sewing speed
Trimming thread speed
The beginning
reinforced sewing speed
The finishing
reinforced sewing speed
“W” sewing speed
Adjusting instruction
Limit the maximum beginning speed
Limit the maximum sewing speed
Limit the maximum fixed-length
sewing speed
Limit the maximum manual
sewing speed
reinfored
The speed of mainshaft when trimming
The speed of mainshaft when the
beginning reinforced sewing
The speed of mainshaft when the
finishing reinforced sewing
The speed of mainshaft
when “W” reinforced sewing
Trial sewing
The control panel parameter can be adjust ,
please refer to the parameter instruction book.
Electronic tension device switch
no thread on upper side
realize clean sewing
in the bottom side
Needle Position
Press and hold button ,press button at the same time ,
enter into “system programmer parameter mode”
P42: needle position up adjustment
With this parameter can realize machine to stop at any angle position
When adjust the parameter, make sure to rotate the hand wheel by hand ,after adjust to a suitable position
and then,press button “ P” to save
P43: needle-down position down adjustment
With this parameter can realize machine to stop at any angle position
(adjustment method is the same as P42)
8
9
Summary of Contents for JK-SHIRLEYIIE
Page 18: ...MEMO MEMO...