1.4
针数变换说明
NEEDLE NUMBER CHANG
1.4.1
针数齿轮与
P10
参数对照表:
NEEDLE NUMBER GEAR
AND P10 PARAMETER
COMPARISON TABLE
针数
Needle
Number
83
100
110
123
152
170
19
225
P10
参数
Parameter
3
3
4
5
5
6
7
8
1.4.2
针数变化及开机说明:
NEEDLE NUMBER CHANGE AND INSTRUCTION
每次开机或者更换针数齿轮后,程序需要确认当前花样的针数,因此在开机或者更换针数齿
轮后,缝制前两个锁眼是程序来确定当前花样实际针数的,请不要踩暂停,以免针数计算错
误,出现停针位置不对或者切刀不返回现象。
Each time after start or replace gear, and the program needs to confirm the current pattern of
needle number, so after start or replace needle number gear, first two keyhole is confirmed by
the current pattern of the actual pin number, please don't stop in order to avoid wrong
calculate or wrong needle position
6
Summary of Contents for JK-T718E
