16
/
51
六、缝纫机调整
Sewing machine adjustment
注意：为了防止机器突然启动造成人身事故，请关掉电源，确认电机确实停止转动
后再进行操作
Attention
：
In order to prevent the sudden start of the machine which causing a personal
accident, please turn off the power, make sure the motor does stop rotating before
operating!
1、冷却器导线器的调整
松开紧定螺钉，把各导线杆高度调整为图示的尺寸，然后拧紧紧定螺钉（图7-1），
针对不同布料时可通过调节A、B、C的高度来调节挑线量，导线杆的高度增加挑线
量减小，导线杆的高度降低挑线量增加（图1）。
1
、
Cooler
wire
guide adjustment.
Adjust the release needle thread guide hight to the number below
，
then tightening screw
（
Figure7-1
），
Accounting to different fabric, we can change thread taking up length by
adjusting needle thread guide hight A
、
B
、
C
，
Thread taking up quantity increase when
needle thread guide hight decrease and thread taking up quantity decrease when needle
thread guide hight increase.
（
Figure 1
）。
A
B
C
12
21
32
Summary of Contents for k4 Series
