JackaJay
INSTALLATION GUIDE
15
4 Installation of JackaJay lift system
It is CRUCIAL that the correct colour Motor Assembly and Tube Assembly are
mounted in the instructed positions.
Motor Assembly and Tube Assembly slide together with matching colours.
Wiring Harnesses have matching colour tags fitted to match the corresponding
Motor Assemblies and Tube Assemblies, i.e. red to red, green to green, blue to
blue and yellow to yellow.
The position relates to the telescoping leg being lifted by that coloured JackaJay
corner, i.e. the Green components lift the driver’s side front telescoping leg.
JackaJay COLOUR - CODING POSITIONS
POSITION FOR EACH COLOR
DRIVER’S SIDE FRONT
DRIVER’S SIDE REAR
PASSENGER SIDE FRONT
PASSENGER SIDE REAR
4.1 Corner Bend Installation
Position, but DO NOT fix to the floor, 4 x Corner Elbows (black) into each
corner such that the upper end of elbow fits into the largest (bottom)
stage of the telescoping leg. It should slide in by only around 10mm. If
required, remove only one small screw that scures the lower section of
the telescopic mast. You must ensure that it goes back in
Place a large dob of grease into the bottom of the corner elbow. This is
where the flexible pushrod will slide in and will lubricate the inside of the
corner bend.
STOP POINT 8
You will have all 4 x corners elbows located into the
lower section of the telescopic mast, NOT screwed
down, with a dob of grease inside the lower end.
Tick here
