JackaJay
INSTALLATION GUIDE
16
4.2 Flexible pushrods
Locate the NEW 4 x Flexible Springs/Pushrods, they will be pre-greased.
Remove them from the plastic sleeve one at a time as required.
Locate the dome headed end of the Spring, slide it into the corner
elbow, and feed up until it stops. The dome headed end will be in
contact with the final (smallest) stage of the telescoping leg.
You will have around 45 – 85mm of spring / pushrod exposed from the
lower end of the corner elbow (This varies due to corner height variation).
Position something heavy enough to hold the spring / pushrod temporarily
in position.
Locate one full set, i.e., RED Drive tube and RED motor assembly.
Check that they slide together completely, and the drive shaft fits into the
motors coupler all the way in. See image below for Coupler
STOP POINT 9
You will have all 4 x Flexible push rods installed with
grease seen inside the protruding spring that is
coming out of the corner elbow.
You should have 45 – 85mm of spring protruding.
4.3 Coloured square drive tubes and Motor Assemblies
Follow the steps below for each of the corner’s complete assembly. This should be
done one at a time:
Tick here
