JackaJay
INSTALLATION GUIDE
22
STOP POINT 14
You MUST have all 4 x lift mechanism securely fixed
to the floor and conduct the following checks:
Are the square drive tubes straight? Are flexible
pushrods entering the corner elbow in the middle?
Are the square drive tubes secured by their mount
points near the limit switch?
Is there a minimum 5mm gap between opposing
tubes assemblies?
Is the square bronze block located just 1-2mm off
the limit switch arm?
There MUST be pressure on the spring. If the spring
is loose and can be pushed either up into the
telescopic mast or back into the square tube, then
the motor mount location MUST be adjusted.
Are the motor couplers tight, as well as the couplers
grub screws?
IF ANY OF THE ABOVE CHECKS ARE NOT ACCURATE,
IT MAY AFFECT THE OPERATION OF THE JACKAJAY
LIFT SYSTEM.
4.5 INSTALLING CONTROLLER & HARNESSES
4.5.1 JackaJay Controller
The JackaJay controller is generally installed in the upper
passenger side corner of the front boot of the Jayco Camper
Trailer. If it is an earlier model with no boot, then mount the
JackaJay controller on the vertical foremost wall in the boot
located on the passenger side.
It should be positioned so that you can adequately access the
underside plugs and see the screen below the upper edge of
the boot lid.
Position the controller with the plugs facing downward.
Hold the controller in the desired position and fix to the panel
using 4 x M4 x 18mm self-drilling screws.
Tick here
