JackaJay
INSTALLATION GUIDE
23
STOP POINT 15
The JackaJay controller MUST be installed in a position
where it is readily accessible and not obstructing
storage, so that no damage can be caused to the
cable harness plugs and touch screen.
4.5.2 JackaJay Harness
The complete JackaJay harness kit is made up of 3 individual
harnesses. i.e. 1 x rear harness (long), 1 x front harness (short) and
1 x power harness (length varies due to position of battery).
You need to run the harnesses from the controller, into the front
floor channel where the lift mechanism is laying.
Using a 32mm Hole Saw, drill a hole through a suitable location in
the panel boot back walling panelling. Note: sometimes drilling
a 32mm hole through the side panel and into the winch winder
cavity can be suitable also. It depends on the design of your
camper.
Fit the supplied 32mm conduit bush to ensure that there is no
abrasion of harness.
Feed small plugs of each harness from the JackaJay controller
side of panel through the conduit bush into the cavity where the
JackaJay lift mechanism has been installed.
All color coding MUST be matched up correctly.
Ie. GREEN labelled harness plugs MUST connect to the
GREEN motor assembly plug and GREEN tube limit switch.
FAILURE TO DO SO WILL LEAD TO IREVERSABLE DAMAGE TO
THE LIFT MECHANISM.
VERY IMPORTANT:
Ensure this 32mm hole is hidden inside cabinetry. DO NOT drill through
exposed internal wall.
Tick here