ProPuls 320C
Operating manual
Page 40
16.1 Material strength / welding current / wire speed
A
• Material thickness:
Possible range from 0.6 to 20mm; in increments of 0.1mm
• Welding current:
Possible range from 10 to 330/400/500A in increments of 1A
• Wire speed:
Possible range from 1.2 to 25mm; in increments of 0.1m/min
Repeatedly press the button to select the desired function.
The respective LED illuminates.
The value can be set with the left dial (pos. 2)
NOTE:
The adjustment ranges vary depending on the welding process and the material.
16.2 Left dial (left display)
With this dial, the selected active parameter material thickness / welding current or wire speed can be
adjusted.
Furthermore, the functions in the text display (left half of the display) can be changed.
16.3 Trigger mode 2-step / 4-step / 2-step crater-fill / 4-step crater-fill – current I2 / Spot
/ stitch
Repeatedly press the button to select the desired function.
• 2-step
Press and hold
the torch trigger to weld.
Release
the torch trigger and the welding process ends.
• 4-step
Press and release
the torch trigger to weld.
Press and
release the torch trigger and the welding process
comes to an end.
• Spot
Press and hold
the torch trigger to weld.
welding
The welding current flows for a preset time. Afterwards, the welding process
ends automatically. Release the torch trigger.
To repeat, press and hold the torch trigger again.
To adjust the welding spot time, press the Fx button and set the welding spot
time.
• Stitch
Press and hold
the torch trigger to weld.
The welding current flows for a preset welding time. Afterwards, the welding
process ends automatically. After a preset pause time, the welding process
starts again for the duration of the preset welding time. This process is repeated
until the torch trigger is released.
To adjust the welding/pause time, press the Fx button and set the welding spot
time.
A
LED flashes
Summary of Contents for ProPuls 320 Compact
