5
Bend formed rails down
slightly (if necessary)
Figure 1
Figure 5
Figure 6
Figure 4
Figure 3
Figure
2:
Bottom
view
STEP 1
Remove the cutting board from the right hand side shelf (The side burner can be installed only on the right hand side
of the unit, as it will interfere with the rotisserie otherwise.)
STEP 2
Drop the Side Burner assembly onto the rails that formerly supported the cutting board.
This may be a tight fit; if so, please bend the rails down slightly using a pair of pliers (Fig. 1).
This adjustment will allow the side burner to drop into place.
.
STEP 3
Using the four bolts provided, fasten the side burner to the side
shelf. The bolts screw in through the burner into the shelf. (Fig. 2).
Note the picture is for illustrative purposes only and the bolt will be
screwed into the side shelf.
STEP 4
Install the stainless steel flexible fuel
line onto the 3/8” flared connection on side burner gas manifold.
(Fig. 3: Sealant not required).
STEP 5
Next, insert the flexible fuel line through the hole in left pedestal wall of the barbeque. Note that the hole should be
factory equipped with a grommet to protect the fuel line. Remove the cap at the fuel manifold on your grill (Fig.4, 5),
then connect the flex line as shown (Fig. 6).
