6
Tools Required for Assembly*:
*Please use the proper tools to simplify installation and prevent personal injury or damage to your grill.
A) Installer Supplied Tools:
1
x
Medium Phillips Screwdriver
1
x
5/16” Wrench (or 8mm)
2
x
¾’ Wrench (or 19mm)
Assembling & Preparing Your Grill:
B) Install Flame Diffusers, Cook Grids and Warming Rack:
1. Remove the flame diffusers from the packaging. Please ensure that all protective plastic has been removed.
2. Install the diffusers directly above each burner, by slotting them onto the small pins on the front and rear wall of
the firebox (Fig. 1). Please ensure that the diffusers sit down correctly in their slots, to optimize diffuser function.
3. Install the Cook Grids on the upper ledges of the firebox (Fig. 2)
4. Remove warming rack from packaging and install above cooking grids on the 2 side brackets (or ledges) on
the inner hood.
C) Rear Burner Spark Igniter:
1. Unscrew the plastic/rubber cap from the rear burner ignition module.
2. Insert the supplied AA battery with the positive end facing out. (Fig. 3)
3. Re-install cap.
4. To test the Igniter; push the Igniter button and hold. The ticking noise
from the electrode indicates that the Spark Ignition is working fine!
Figure 1
Figure 3
Figure 2
