5351 E. Thompson Road, Suite 128
Indianapolis, IN 46237
Phone: 888.359.0365
www.specifiedcontrols.com
Option
CANCEL
NEXT
ENTER
22
Automatic Backup
The HVAC Control Module saves the previous 24-
hour pattern of heating, cooling and fan calls in
memory. Should the module lose
communications with the thermostat because of a
low battery or other reason, the module
automatically repeats the call pattern of the
previous 24 hours.
Press the
NEXT
key to select
Option 16
and the
Up
or
Down
key to set the Backup
On
(01) or
Off
(00). It is highly recommended that this option be
left on.
8
Option
CANCEL
NEXT
ENTER
comparing the temperature readings. Press and
hold the
ENTER
key for seven seconds until the
LCD displays Option 01. Press the
NEXT
key
until Option 17 appears. Use the
Up
and
Down
keys to set the proper temperature to be
displayed and then press
ENTER
.
This installation manual should not be left
with unauthorized users as it contains
installer setup functions which, if not
correctly set, may cause damage to the HVAC
equipment or seriously affect performance.
This manual is to be used in conjunction with the
supplied User Manual.
Although great care has been taken in
preparation of this manual, Specified Controls
takes no responsibility for errors or
omissions contained herein. It is the
responsibility of the installer to ensure that
this thermostat and the equipment connected
to it operate in a safe and efficient manner.
Due to ongoing product improvements, Specified
Controls reserves the right to change the
specifications of the SC-WCT32 thermostat or its
components without notice.
All rights reserved.
©
Specified Controls 2010
Intellectual rights apply.
SC-06-1187-062314
Set To
Set To
MENU
Calibrating the Temperature
Sensor Offset
Typically, it is not necessary to adjust the
temperature calibration offset from the factory
setting. If calibration is necessary, a high quality
electronic digital thermometer must be used. Place
the thermometer sensor probe next to the
thermostat sensor and allow five minutes before
Inside
CANCEL
NEXT
ENTER
23
Resetting Factory Defaults
To reset the factory defaults, remove the batteries
and re-install them while holding down the
SYSTEM
key. All prior changes will default to the
factory settings. This will require resetting the
time of day and programming schedules if
necessary. Refer to the Installer Options Chart
default settings to make any additional changes.
Option
