GENERAL INSTRUCTIONS
(INSTALLATION)
REFER TO SPECIFICATION SECTION FOR FURTHER DETAILS.
Note: Read the following instructions carefully. Proper installation of your Jackson
Dishwasher will assure proper machine operation.
Uncrating 24:
1. Remove wooden blocks from carton.
2. Slide carton sleeve upward over top of dishwasher, set to one side.
3. Remove bolts holding wooden base to machine and screw in adjustable feet supplied. (Feet are
inside of dishwasher.)
4. Set dishwasher in place, ready for installation
Note: NSF base cradle must be field installed on all 'F' and 'P' models. Cradle goes under
machine and must be sealed in place using silicone sealant.
Installation Instructions:
1. The dishwasher can be leveled to the proper height by adjusting the feet on the four corners.
The
front of the unit must be
1/4
"
to
1/2
"
higher than the back.
2. Refer to the dimensional data sketch for connections.
3. The drain from the machine is a GRAVITY DRAIN SYSTEM and should have the proper drop from
the machine to an open floor drain, vented to atmosphere. The drain connection is located to the left
rear of the machine when facing the machine's door. The drain fitting is I 1/2" OD tube size, 7" from
floor.
4. IMPORTANT — PLEASE READ — Located on the back upper left corner of the unit is a steam
equalizing vent. This vent in no way should be blocked or prevented from allowing steam to be
vented to the outside of the unit or from under the cabinet in which the unit is installed. Never pipe
the steam downward toward the floor. (SEE PAGE 5 IF IT IS BEING INSTALLED UNDER A
COUNTER.)
5. The electrical connections should be made to the terminal board located at the center front. The
terminals are marked L1, L2, and Neutral. Install proper circuit breaker and conduit size to conform
with local and/or national codes (standards). USE COPPER WIRE ONLY (#8 AWG).
Summary of Contents for 24A-AF
