Position the blower unit around the waist at the centre of the back to minimize the risk
of the blower or hose becoming caught up in use.
ATTACHING THE HOSE TO THE PAPR BLOWER UNIT
Align the pins of the hose bayonet connector with the bottom of the arrow on the air
outlet of the blower. Push the bayonet connector into the blower until it reaches the
bottom of the hole and then twist in a clockwise direction on blower side until the
locating pins clip into place. Repeat the process by turning counter clockwise to lock the
other end of the hose to the head top.
FITTING THE WELDING HELMET
• First set the welding head top rake and adjust the welding filter to suit. Lift the
helmet to its upper position
• Place over the head and adjust the headgear ratchet wheel by rotating it until a
satisfactory tightness is achieved
• Pull the elasticized chin guard downwards and at the same time pull the helmet
down
• The welding head top is then ready for use.
7
