5
Before installing the machine, check packaging and machine for damage. Damaged
packaging might be an indication of damage to the machine. If there is any type
of damage to both packaging and machine, do not throw away the packaging. The
machine has been inspected at the factory before shipping and is expected to arrive
in new, undamaged condition. However, rough handling by carriers or others might
result in damage to the machine while in transit. If this occurs, do not return the
machine to the manufacturer. Instead, contact the carrier and ask them to inspect the
damage and complete an inspection report.
Contact the carrier within 48 hours of receiving the machine as well as the dealer that
sold you the machine.
The machine should be unpacked and removed from the pallet before installing. Open
the front door and remove all materials from inside. Once unpacked, verify there are no
missing parts. If a part is missing, contact the manufacturer immediately.
The machine is designed to operate while level. This is important to prevent any
damage to the machine during operation and to ensure the best possible results.
The machine comes equipped with adjustable bullet feet which can be turned using
a pair of pliers. Verify the unit is level from front-to-back and side-to-side before
making any electrical or plumbing connections.
The manufacturer does NOT endorse “Tankless On-demand” water heaters for use
with their machines. The manufacturer DOES endorse, and highly recommends,
the standard “Tank” style water heaters, sized to properly handle the water heating
requirements of the facility.
All plumbing connections must be made to adhere to local, state, territorial, and
national codes. The installing plumber is responsible for ensuring the incoming
water lines are flushed of debris before connecting to the machine. Note that chips
and materials from cutting processes can become lodged in the solenoid valves
and prevent them from opening or closing. Any valves that are found to be fouled
or defective because of foreign matter left in the water line, and any subsequent
damage, are not the responsibility of the manufacturer.
A water hardness test must be performed. If water hardness is higher than 3 GPG,
install a water softener or install the optional Scale Prevention System (SPS). See
next section and Plumbing Options page for more information on the SPS.
INSTRUCTIONS
INSTALLATION
INSPECTION
LEVELING
UNPACKING
Do not throw away
packaging if damage is
evident!
FACILITY HOT
WATER HEATER
PLUMBING
A water hardness test
must be performed.
CAUTION!
The plumber
must flush the incoming
water line!
!
CAUTION
