OPERATION 5
17
5.4
STARTING________________________________________________________________
1.
Sit in operator’s seat, make sure the PTO switch
(Q)
is
OFF (down) and the parking brake is engaged. Remove
feet from pedals. Always use the seat belt when
operating mowers equipped with a ROPS.
2.
Set throttle lever
(T)
to half throttle and check that
alarm switch
(O)
is ON.
3.
Turn ignition switch
(V)
to ON (
) position.
Note:
At this time the warning lights
(N, Y)
on the
instrument panel will come on. Check that lights are
operating.
Wait until glow plug light goes out, then immediately
turn ignition key to “START” (
) position. Release as
soon as engine starts. Allow 30 seconds between start-
up attempts to allow time for engine starter motor to
cool.
All warning lights should go off after engine starts.Allow
engine to gradually become warm before operating at
high RPM.
Figure 5A
5.5
STOPPING / PARKING ______________________________________________________
To stop:
Remove your foot from traction pedal.
The mower will
automatically brake when the traction pedal returns to
NEUTRAL. Always engage parking brake, shut off engine,
and remove key before leaving operator seat for any reason.
To park the mower under normal conditions:
1.
Disengage the PTO switch
(Q)
then raise and lock the
implements in the transport position and move away
from the area of operation.
2.
Select a flat and level area to park.
a.
Release traction pedal to bring the mower to a
complete stop.
b.
Disengage all drives, lower implements to the
ground, engage parking brake, reduce throttle to
idle, and allow engine to operate at no load for three
to five minutes.
3.
Engage parking brake, stop the engine, and always
remove the ignition key.
If an emergency arises and the mower must be parked in
the area of operation, follow the guidelines outlined by the
grounds superintendent. If the mower is parked on an
incline, chock or block the wheels.
NOTICE
IMPORTANT:
Do not use starting assist fluids.
Use of
such fluids in the air intake system may be potentially
explosive or cause a “Runaway” engine condition and
could result in serious engine damage.
WARNING
To prevent injuries, sit in the seat, engage parking
brake, place traction pedal in neutral, and PTO switch
in OFF position before attempting to start the engine.
NOTICE
Do not hold key in “START” position for more than 10
seconds at a time. After 10 seconds the starting circuit
will shut down and must be reset by returning the key to
the OFF position.
!
TC-O/I
77
93
110
° C
170
200
230
° F
!
WARNING
1. Read operators manual,
do not allow untrained
operators to use machine.
2. Keep shields in place
and hardware securely
fastened.
3. Before you clean, adjust
or repair this equiptment,
disengage all drives,
engage parking brake
and stop engine.
4. Keep hands, feet and
clothing away from
moving parts.
5. Never carry passengers.
6. Keep bystanders away.
7. Inspect hoses and fabric
covers daily. If worn or
damage, replace with
original quality parts.
8. Do not use on slopes
greater than 22 °.
4131828
T
o
tal Hour
s
1
10
0
0
0
0
0
Q
Y
N
V
O
T
NOTICE
Permanent damage to the turbocharger may occur if
the engine is shut down without allowing the
turbocharger time to cool.
To prevent damage, operate the engine at idle with no
load for 3 to 5 minutes before shutting off engine.
