CONTROLS 6
en-30
6.2.1 IGNITION SWITCH _________________________________________________________
The ignition switch has three positions, OFF, RUN and START. In the run
position, the controller program is active and input and output circuits are
monitored.
6.2.2 4WD REVERSE SWITCH ____________________________________________________
For additional traction when you drive in the reverse direction, the 4WD-traction circuit can be
engaged for a short time. Press and hold the front of the 4WD reverse switch to engage the
4WD-traction circuit.
NOTE:
The 4WD switch must be in the ON position for the 4WD reverse switch to function.
NOTE:
When the 4WD switch is pressed with the traction pedal pressed in the reverse position,
the mower speed will decrease. Do Not engage the 4WD reverse switch with the traction pedal
in the forward direction.
When the switch is released, the mower will return to 2WD in the reverse direction.
6.2.3 4WD SWITCH _____________________________________________________________
The 4WD switch controls the operation of the 4WD traction system. Press the front of the switch
to engage the 4WD traction circuit.
NOTE:
When the 4WD-traction circuit is engaged with the traction pedal pressed in the forward
position, the mower speed will decrease.
Press the rear part of the switch to return to the 2WD traction circuit.
NOTE:
When the 4WD-traction circuit is disengaged with the traction pedal pressed in the
forward position, the mower speed will increase and the cutting units will stop.
NOTICE
The 4WD switch must be in the ON position for the PTO switch to engage the mowers.
OFF
RUN
START
Summary of Contents for HR-9016 Turbo
Page 13: ...SPECIFICATIONS 4 en 12 K L D B A P P N C J H M E G...
Page 28: ...5 DECALS en 27...
Page 90: ...13 NOTES en 89 13Notes...
Page 91: ...NOTES 13 en 90...
