GB-15
RANSOMES HR3806 Series: DZ
SAFETY AND OPERATORS MANUAL
6
CONTROLS
6.10
INSTRUMENT PANEL
A.
ENGINE PREHEAT INDICATOR LAMP
Colour green, on when the ignition switch is turned
clockwise to the pre-heat position. Once the lamp
goes out the engine can be started.
B.
ENGINE TEMPERATURE GAUGE
Indicates current temperature of engine, whilst
running.
C.
HYDRAULIC OIL WARNING LAMP
Colour red, on when the hydraulic oil temperature
reaches a preset level. If the lamp comes on bring
the machine to a stop, disengage the cutting units,
apply the parking brake and stop the engine. The
lamp will also turn on when the charge filter is
blocked.
D.
CHARGING WARNING LAMP
Colour red, on when ignition is switched on and will
go out when the engine is started. If the light comes
on while the engine is running, the fan belt may be
slipping or broken or a fault in the electrical system
is indicated and should be investigated. STOP
IMMEDIATELY.
E.
ENGINE OIL PRESSURE WARNING LAMP
Colour red, on when the ignition is switched on, and
will go out once the engine has started. If the light
comes on while the engine is running - STOP
IMMEDIATELY as this indicates that the engine oil
pressure is too low. Check the level of oil in the
sump and top up as necessary. Check the oil
pressure sender switch. Continued operation may
cause extensive damage to the engine.
F.
FUEL GAUGE
Located to the left of the engine temperature gauge.
Monitors fuel level.
G:
PTO SWITCH
To commence cutting ensure the decks have been
lowered Push bottom of the rocker switch (A) and
depress foot switch. Push top of rocker switch to
stop cutter unit rotation. (Cutting units stop rotating
automatically when raised.)
H:
HEADLIGHT SWITCH
(Optional equipment )-Push switch half way for
running lights. Push down fully for headlights
I:
HAZARD LIGHTS SWITCH
(Optional equipment)- Push down for flashing hazard
lights.
J:
TURN SIGNAL LIGHTS SWITCH
(Optional equipment )-rotate switch handle
counterclockwise for L.H. turn and clockwise for a
R.H. turn.
K:
HORN
(Optional equipment) press switch to operate the
horn.
L:
ROTATING BEACON
(Optional equipment) Press the bottom half of the
switch to activate the flashing beacon.
Summary of Contents for ransomes hr3806
Page 2: ... 2004 Ransomes Jacobsen Limited All Rights Reserved ...
Page 59: ......