en-13
FITTING INSTRUCTIONS 3
3.5
REPLACE PIVOT SHAFT IF REQUIRED ___________________________________
To improve access with the removal of the MP/HR decks, make sure there is enough space both sides of the
machine.
For older machines with Pivot Shaft without M16
tapped hole.
Removing Pivot Shaft (E)
1.
Remove screw (A) and washer (B) and
discard.
2.
Remove screw (C) and washer (D) and
discard.
To fit new Pivot Shaft.
1.
Fit pivot shaft through wing deck frame and
lift arms. Align hole in keep plate with
threaded hole in wing deck frame.
2.
Fit screw (G) and washer (H). Apply thread
lock to screw (G) and torque to 26-28 Nm.
3.
Fit screw (J) and washer (K).
Repeat above procedure on other wing mounting.
A
B
C D
E
J
K
H
G
F
