OPERATION 7
en-30
7.7
HEIGHT OF CUT ___________________________________________________________
The height of cut is determined by the location of the HOC pin. Engage the parking brake, stop the engine and remove
the key before you change the HOC.
Use the chart to find the correct cutting height hole for the necessary HOC.
7.8
MOWING
_________________________________________________________________________
To mow:
1.
Put the PTO switch in the ON position. The blades will start turning.
2.
Press the button on the HOC lever and lower the cutting unit.
3.
Push the steering control levers forward to drive the mower. Never mow in the reverse direction.
4.
Slow down when you turn the mower or mow on slopes.
HOC
HOC
Hole
Hole
1
1-1/2 Inch (3.8 cm)
8
3-1/4 Inch (8.3 cm)
2
1-3/4 Inch (4.4 cm)
9
3-1/2 Inch (8.9 cm)
3
2 Inch (5.1 cm)
10
3-3/4 Inch (9.5 cm)
4
2-1/4 Inch (5.7 cm)
11
4 Inch (10.2 cm)
5
2-1/2 Inch (6.4 cm)
12
4-1/4 Inch (10.8 cm)
6
2-3/4 Inch (7.0 cm)
Fully Raised
4-1/2 inch (11.4 cm)
7
3 Inch (7.6 cm)
WARNING
To prevent injuries, when the blades rotate, keep your hands, feet and clothing away from the cutting unit.
NEVER
use your hands to clean the cutting unit. Use a brush to remove grass from the blades. The blades can be
sharp and can cause injury.
DO NOT
operate the cutting unit without the discharge deflector installed.
2
1
4
3
6
5
8
7
10
9
12
11
2
1
4
3
6
5
8
7
10
9
12
11
!
