38
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Owner’s Guide
The oil dipstick/fill cap must be in place before operating the engine. Failure to install the dipstick/fill cap will result in
oil contamination or oil being discharged into the engine compartment.
Changing the Oil
Tool List
Qty.
Tool List
Qty.
Socket, 19 mm ............................................................ 1
Oil Filter Wrench ......................................................... 1
Ratchet ........................................................................ 1
Oil Drain Pan............................................................... 1
Extension, 8" ............................................................... 1
For maximum performance and longevity, replace the engine oil
after the first 8 hours of operation. After the initial oil change,
change every 125 hours of operation or semi-annually, whichever
comes first.
The selection of oil is dependent on the service that the vehicle
will perform. Most vehicles require 10W-30 oil, whereas vehicles
used at capacity or near capacity load applications needs 10W-40
oil after a break-in period of 100 hours.
If vehicle is to be stored over winter months, it can be stored
with old oil left in engine. The oil should be changed as part of
spring maintenance to remove any moisture that has accumu-
lated during storage.
Be aware that engine fluids may be hot and contact to the skin may cause severe burns. Wear
rubber gloves to protect skin from exposure to the old oil and degreaser.
The oil should be changed when the engine is warm. Park the vehicle on a level surface, engage the parking brake and
remove the key.
Place a drain pan under the engine. Wipe top of the engine clean with a
cloth. Remove the oil fill cap.
Be careful of hot oil when drained. It may be hot
enough to burn you severely.
-20
0
20
40
60
80
100
-30
-20
-10
0
10
20
30
40
C
F
0
0
10W-30
10W-40
HEAVY DUTY WORK
LIGHT DUTY WORK
(AIR TEMPERATURE)
10W-30
Oil Fill Cap
