4/21
3.
Fill with the plant protection product. Do not remove the
cone lid for filling. It iprevents against spillage of chem-
icals;
4.
Install the cylinder again and rotate clockwise to lock it;
5.
Unlock the handle and pump at least 30 times or until the
pressure relief valve opens;
6.
Lower the handle and turn it clockwise to lock it;
7.
The sprayer is ready for use and can be transported verti-
3.5. Spraying
The blue adjustable cone nozzle that comes along with this
compression sprayer can be adjustable to apply as a spray or a
jet. As shows below:
4. Storage and Maintenance
1.
The sprayer must not be stored with any chemical inside
and / or stored with internal pressure.
2.
After the application, remove all internal pressure, empty
the tank, clean and wash all equipment in a place where
there is no risk of contamination.
3.
Periodically lubricate the sprayer by removing the handle
from the cylinder and lubricating the piston ring as indi-
cates in the figure below:
cally on the shoulder by the strap;
8.
After spraying, remove the internal pressure by lifting up
on the pressure relief valve according to the operation 1.
