Jacto J600, Assembly Manual

03/23/05                          J600CHT Assembly – DRAFT              Prepared for Jacto  
                                                                                                        Service Seminar 3/2005 
                                                                                                        DRAFT COPY 

Auxiliary Duct Assembly  

 
 
 
1)

Install the two auxiliary ducts onto the movable duct with clamps as shown 

below.  Next install the hoses that connect to the main duct nozzle and auxiliary duct 
nozzles and tighten the hose clamps.  Route the two supply hoses through the hose 
retainer clips on the duct and tighten.  These two hoses should then be routed through 
the hose loops on the back of the duct and then threaded into the orange sheath up to 
the control valve and the ends installed onto the control valve.  The 6 JA nozzles and 
swirl cores need to be installed on the auxiliary duct nozzle branches by removing the 
nozzle caps and removing the protective disc and inserting the nozzle filter, nozzle 
and swirl core. 
 
 
 
 
 
 
 
 
 
 
 
   
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Retainer Clips 

Auxiliary Duct 

Nozzle Branches