20
CHAPTER 4 - OPERA
TION AND ADJUSTMENTS
J-600 ELECTRIC
Chemical container rinse
ATTENTION!
Never pull the directional valve with-
out the chemical container over the
container rinse nozzle.
After rinsing the chemical container,
wash it for the last time.
> Washing the chemical container
∙ Fill the chemical container with water up to
1/4. Fit the container cap and tight it enough to
avoid leakage during the agitation.
∙ Shake the container strongly in all ways (hori-
zontal and vertical), for approximately 30 sec-
onds to remove the residues that are attached to
the inside of the container.
∙ Take the container cap off and carefully pour the
rinse water into the spray tank.
∙ Keep holding the container over the spray tank
opening until it is completely empty.
∙ Next , pierce the side of the container so it can’t
be used anymore. But do not damage the label
which identifies the chemical that was inside.
NOTE:
To keep from contaminating the
water and the clean water tank
tap during the filling of the chemi-
cal container, hold the container at
least 2 in away from the tap and fill
the chemical container with water
up to 1/4, as shown.
> Container rinse
2 in
2 in
