Control Panel
The control panel is easy to use with fingertip control of all the spa's functions. Control of temperature, jets and
spa light is readily accessible from within the spa.
The spa will automatically begin to operate when electrical power is applied. There is no ON/OFF switch for the
spa system.
The control system has been designed so that by connecting the spa to its properly grounded power source, the
spa's set temperature is preset to 100
°
F. Your spa's readout will display the water temperature, and the spa will heat
to the set temperature. The first filter cycle will begin one minute after the spa is energized.
Temperature Controls
The current temperature is constantly shown on the
display. After pressing the button once, the display will
show the set temperature. Pressing the button a second
time will cause the set temperature to increase or
decrease depending on what direction was last chosen.
Each successive press will change the set temperature
in the same direction.
If the opposite direction is desired, release the
button and let the display revert to the actual water
temperature. Press the pad to display the set tempera-
ture and again to make the temperature change in the
desired direction.
Temperatures from 80
°
to 104
°
F can be set.
Jets Control
Press the
button once to activate the low-
speed jet operation. Press the button again for the high-
speed jet operation, and again to deactivate the jets.
The low-speed jet operation will start automatically
when the heater is turned on or when a filter cycle is
activated. When a freeze condition is detected, high
speed jets are automatically activated.
Whenever the low-speed is energized with this
button, it will automatically turn off after 4 hours of
operation. The high-speed automatically turns OFF
after 30 minutes.
Light
The
button activates and deactivates the spa
light.
The spa light will automatically turn OFF after 4
hours of operation.
13
•
••
•••
L O W
HIGH
O F F
Status/Heat
Select
SERIES
TEMPERATURE
JETS
LIGHTS
WATER TEMPERATURE READOUT
I 0 I F
Control Panel
OPERATION
