English
Arga™ Bathtubs
Operation Instructions
www.jacuzzi.com
Page 7
General Operating Instructions
Operation & Maintenance Instructions
All bathtubs manufactured by Jacuzzi Luxury Bath are designed for “fill and drain,” which means the bathtub should be drained
after each use and filled with fresh water by the next bather. This is a health precaution, as these bathtubs are not designed to hold
water continuously like pools or spas.
Close the drain and fill the bathtub until water is at least 1” to 2” (25 mm to 51 mm) above the highest jet (see water line indicated in
the illustration - Fig. 1). Do not turn on the system at any time if the jets are not completely immersed in water. Running the system
when there is insufficient water in the bathtub could result in water spraying outside the bath area.
ATTENTION:
When exiting the bathtub, the water level will drop below the jets which could result in water being sprayed out
of the unit. To prevent this, you must turn unit OFF before exiting bathtub.
To remove accumulations of bathtub residue from the system, it is recommended that Swirlpool
™
bathtubs be cleaned at least
twice a month. For best results, we recommend that you clean your tub after each use using Systems Clean
™
, our exclusive two-
part plumbing system cleaner made exclusively for experience bathtubs. Systems clean is available through jacuzzi.com/baths or
call us direct at 1-800-288-4002.
Clean the suction cover/strainer of hair and debris when necessary (Fig. 2).
1. Remove the screw and detach the suction cover.
2. Clean the cover by back flushing debris from the holes.
3. Replace the suction cover immediately after cleaning.
WARNING!
When reinstalling, orient the cover/strainer with the holes facing
up.
DANGER:
RISK OF SEVERE INJURY OR DROWNING!
Keep hair a
minimum of 6 inches (152 mm) away from the suction fitting at all times when the whirlpool system is operating. Hair longer
than shoulder length should be secured close to the head, or a bathing cap should be worn.
DANGER:
RISK OF SEVERE INJURY OR DROWNING!
Do not operate the Swirlpool
™
system with the suction
cover/strainer removed! It is a safety device and must always be in place on the suction fitting to minimize the potential
hazard of hair and body entrapment.
Cleaning - Systems Clean™
Suction Cover/Strainer Maintenance
Fig. 2
Fig. 1
