English
Arga™ Bathtubs
Operation Instructions
www.jacuzzi.com
Page 11
Activate the waterfall after starting the Swirlpool
™
function (and adding Jacuzzi® Epsom Salts in step 3 if desired) by touching
the
button briefly (the function starts after lifting your finger) (Fig. 7).
WARNING:
Do not press multiple times. Do not
block the waterfall outlet at any time.
ATTENTION:
The waterfall cannot operate if the
Swirlpool
™
function is not activated.
Once the
button is touched, the Illumatherapy
™
lights will flash blue (Fig. 8). The salt infuser will mix the salts for
approximately 10 seconds before the waterfall action begins. If the waterfall is activated without salt, the 10 second mixing still
occurs.
The waterfall will continue to operate throughout the Swirlpool
™
experience, or can be turned off if desired by touching the
button again.
Note: After the waterfall is turned off, the salt infuser will slowly drain into the tub. As such, adding salt to the infuser after the
waterfall has run during a bath will allow a small amount of dissolved salt to drain into the tub. This is normal and will not cause
any issues for the bath.
The Illumatherapy
™
light system can be used at any time while the bath is filled or empty. To activate, simply touch the
button briefly (the lights activate after lifting your finger) (Fig. 9). The lights will activate on the rainbow cycle.
To change color, touch the
button again to move through the colors in Figure 10. Hold
for 2 seconds at any time to turn
off the lights. The lights are programmed to turn off after 30 minutes.
Waterfall
Illumatherapy™ Light System
Experience Arga™
5
6
7
4
Fig. 10
Fig. 9
Fig. 8
1
2
Fig. 7
1. Activate Lights on
Rainbow Cycle
2. Blue
3. Red
4. Yellow
5. White
6. Turquiose
7. Green
8. Orange
9. Magenta
