English
Page 8
www.jacuzzi.com
Operation Instructions
Arga™ Bathtubs
CAUTION:
Do not use oil or oil-based bathtub additives. Never use abrasive cleaners on any Jacuzzi Luxury Bath product.
Arga
™
Swirlpool
™
bathtubs are intended for use with Jacuzzi® Epsom Salts.
If you want to use any other kind of bathtub additive, use only a small amount of low-foaming powder or crystal substance; the
system action intensifies the foaming properties of soaps.
The use of certain bathtub oils, bubble baths, and bathtub additives may increase the level of accumulations of bathtub residue in
the system and may cause false reading of the water level sensors. If excess accumulations persist, you should discontinue use of
these products.
After each use, remove & rinse the filter basket to remove any residue (Fig.
3).
ATTENTION:
If anything becomes trapped or dried into the strainer,
first soak the filter basket in dish soap and warm water, then scrub as
needed with a brush.
Bathtub Additives
Operation & Maintenance Instructions
Filter Basket Maintenance
4-PIN RECEPTACLE
4-PIN PLUG
NOT USED IN
4-JET CONFIG.
CONTROL KIT
120V 15A
GFCI
PUMP
SALT DISCHARGE
ON/OFF VALVE
JET ASSEMBLY
W/ LED
LIGHT WIRING, 1600MM
LIGHT WIRING, 500MM
CONTROL PANEL
LIGHT WIRING CONNECTORS
WATERFALL
BUTTON
SWIRLPOOL™
BUTTON
ILLUMATHERAPY™
BUTTON
J6 Control Panel Swirlpool™ System Reference Illustration
Fig. 3
