34
Low water level
Add water up to the
normal
level
Motor bearings worn or faulty
*
The impeller rubs against the pump body
*
Solid bodies in the pump
*
Water leakage from shaft
Pump mechanical seal worn or defective
*
of the pump (rotating joint
between the pump and the motor)
The motor does not start
No power
Turn on the mains switch
Main switch has tripped
Turn on switch
Voltage too low
Contact an electrician or the organization
that provides electricity
Circuit breaker has tripped
Reset breaker
Incorrect or faulty connections
*
Shaft and impeller blocked
*
Motor windings burnt
*
Faulty contact on motor
*
start-up
The motor stops
The function has ended
Press the key again
Overload
Let the motor cool,
the problem should disappear.
If it persists, see *
Power supply cables not suitable
Consult an electrician
The blower (air compressor)
No power
Turn on the main switch
does not operate
Two hydromassage pumps are on
Turn off a pump and turn on the blower
The
button
has not been fully pressed
Press the button again
Main switch has tripped
Turn on switch
Circuit breaker has tripped
Reset breaker
Faulty
motor *
*
:
This type of repair requires the intervention of qualified personnel.
Contact your Jacuzzi® dealer or an authorised Service Centre.
It is the responsibility of the installer/owner to ascertain compliance with specific local regulations prior to installation. Jacuzzi Euro-
pe S.p.A. gives no guarantee in this respect and declines all responsibility regarding the compliance of the installation performed.
Summary of Contents for DELFI PRO
