Era™ Freestanding Bath
Era™ Freestanding Bath
Installation and Operation
www.jacuzzi.com
Page 11
English
Support Leg Assembly
X
X
Fit each frame leg into place using the ring’s metal brackets as
locators. Attach each leg to the frame rail using two (2) Phillips
head screws (Figure 15). Do not completely tighten the mounting
hardware at this time.
X
Y
Using the inset illustrations as reference, slide the support legs
towards the outer most edge of the frame rail.
X
Z
Once the support legs are in position, use a Phillips head
screwdriver to tighten all mounting hardware.
Be sure all corresponding letters match.
Figure 15.
Wood Frame Assembly
Inset
Inset
Phillips
Screwdriver
Outer most edge
Outer most edge
X
[
Once all four (4) metal brackets have been attached, use
a Phillips head screwdriver to tighten all of the mounting
hardware (Figure 14).
Do not overtighten the mounting hardware. There are
threaded inserts located inside the support legs. If
these threaded inserts are overtightened, they may get
damaged.
Figure 14.
Wood Frame Assembly
Phillips
Screwdriver