Era™ Freestanding Bath
Era™ Freestanding Bath
Page 12
www.jacuzzi.com
Installation and Operation
English
Era™ Freestanding Bath
Center Support Block Assembly
X
X
Install center support blocks by placing them under each center horizontal support (Figure 16).
X
Y
Align the mounting holes of the horizontal braces with the mounting hole on each support block.
X
Z
Insert and tighten, using a screwdriver, two (2; 1 each support block) Phillips head screws.
X
[
Use a level to insure that the wood frame is level.
X
\
If it is not level, use the foot adjustment knob (located under each support block) to properly adjust the level of
the wood frame.
Phillips
Screwdriver
Phillips Pan
Head Screw
Support
Block
Horizontal
Brace
Figure 16.
Center Support Block Assembly
Placing the Bathtub in the Wood Frame
X
X
Lower the bathtub into the wood frame.
X
Y
Align the mounting holes of the horizontal braces
with the mounting holes on the bathtub (Figure 18).
X
Z
Insert and tighten one (1) rubber gasket, one (1) flat
washer and one (1) hex head bolt into the mounting
point on the bathtub (Figure 18 - Inset). Use an
Allen wrench (supplied) to tighten the hardware.
X
[
Repeat steps 2 and 3 for the remaining three
mounting points.
It is strongly recommended that two people perform
the following steps.
Bathtub
Wood
Frame
Figure 17.
Bathtub Placement
Figure 18.
Securing the Bathtub
Bathtub
Horizontal
Brace
Rubber
Gasket, Flat
Washer and
Hex Head
Bolt
Allen
Wrench
When placing the bathtub inside the wood frame,
make sure that the overflow opening is on the same
side as the drain/overflow gap that is located on the
wood frame (Figure 17). This gap will allow you to
attach the drain/overflow assembly.
Overflow
Opening
Drain/
Overflow
Gap
