Page 6
Installation and Operation
Page 5
Installation Instructions
Installation instructions:
1. Attach the S-Union to the tub with flat metal washer and 1/2” lock nut. Make sure the escutcheon is tight against the
S-Union arm ( hand tight only).
2. Attach faucet to S-Unions (3/4” fiber washers must be installed) and adjust faucet so that it sits level. Now tighten hex
nuts on back of faucet to secure the S-Unions. Then tighten the 1/2” lock nuts on the back of the S-Unions to secure
faucet on vertical surface.
3. Next connect the water supply lines. Ensure hot goes into the hot side and cold goes into the cold side. If using 1/2”
OD decorative supply lines, connect the hex nuts at the top of the supply lines to the back of the S-Unions. If installing inside
the wall use, copper fittings.
4. Install the hand shower cradle onto the top of the faucet body. Place the rubber washer in the hex nut at the base of the
cradle and tighten until sealed and secure.
5. To install the shower hose, place the 1/2” rubber washers in the cone nuts at both ends of the shower hose. Install one
end to the side port on the cradle stand and one end on the bottom of the hand shower. Hand tighten.
6. Once installed, remove aerator and hand shower to flush faucet and water lines. This will remove any debris that may be
trapped. Then reattach aerator and hand shower.
Installation Instructions - Wall-mounted faucet
Component Parts List
Installation instructions:
1. Discard the S-Union from the faucet.
2. Next connect the water supply lines to the back of the faucet. Ensure hot goes into the hot side and cold goes into the
cold side. Tighten hex nuts onto supply lines, being careful not to damage the finish.
4. Install the hand shower cradle onto the top of the faucet body. Place the rubber washer in the hex nut at the base of the
cradle and tighten until sealed and secure.
5. To install the shower hose, place the 1/2” rubber washers in the cone nuts at both ends of the shower hose. Install one
end to the side port on the cradle stand and one end on the bottom of the hand shower. Hand tighten.
6. Once installed, remove aerator and hand shower to flush faucet and water lines. This will remove any debris that may be
trapped. Then reattach aerator and hand shower.
Installation Instructions - Freestanding supply lines
ERA
TM
Freestanding Tub Faucet with Hand Shower
