34
■
Pull the mixer lever (1) to open the water flow and turn it to adjust the temperature.
■
When the water is at the required temperature, turn the dial (3) to the required func-
tion.
3
2
1a
1
3
2
1a
1
A
B
C
E1
E2
■
In these models, it is easier to adjust the water temperature because the temperature
is shown in degrees centigrade (°C) directly on the thermostat mixer dial.
It is advisable to set the water temperature to the required value before using any
function with the hand shower or the tub filling jet. Proceed as follows:
■
Turn the knob (1) to make the reference notch coincide with the chosen value. The
knob is provided with a safety stop which blocks the temperature at 38°C; press button
(1a) to release the knob to select hotter temperatures.
■
To test the water temperature, turn the diverter valve dial (3) to the “tub filling” position
(A) and turn the stop tap (2) to make water flow.
■
Once the required water temperature is reached, turn the diverter valve dial (3) to the
position of the required function.
IMPORTANT
: it is advisable to
set the water temperature to the
required value before using any
function with the tub filling jet
Two functions may be used at the
same time: simply turn the diverter
valve dial the mid-way between the
two functions. For example, to use
all nozzles at the same time, posi-
tion the dial between the symbols
(E1) and (E2); obviously, the water
pressure will drop and consequent-
ly so will the power of each jet.
The maximum temperature
of the mixed water must not
be hotter than 60° C.C.
The maximum temperature
of the mixed water must not
be hotter than 60° C.C.
Remember to close the stop tap (2)
after each use. If temperatures higher
than 38 °C are selected, it is advisable
to turn the dial of the thermostat
mixer back before the safety stop.
Remember to close the mixer
after each use
Models with thermostatic
mixer tap
Summary of Contents for hydromassage
Page 26: ...26 Thenewshape ofwell being ...
