37
T
he hydromassage is activated via the buttons incorporated into the panel, where (in some
models) the dials for adjusting the air/water mix from the jets can also be found. Again for
some models, there is also an LED warning light next to the electronic button. This turns on
when the electric pump is powered up.
by
JACUZZI
®
A
B
■
Trip the master switch to turn the tub on.
■
To enjoy a Jacuzzi® hydromassage, simply get into the tub and press the start button
(B).
When in the tub, the water level must completely cover the highest nozzles.
~7 cm
■
The hydromassage is programmed to last for approximately 20 minutes; the cycle will
automatically stop after this time.
Press the start button (B) to stop the cycle before.
■
Refer to the general instructions for use for how to adjust the air-water mixture or the
intensity of the nozzles.
Instructions
for using the
hydromassage
General features
Starting the hydromassage
air-water mixture adjustment
knobs (where included) (
A
)
hydromassage cycle on/off button (
B
)
hydromassage cycle LED (
C
)
All the buttons installed on the
tub rim are powered at very
low voltage for total safety.
The hydromassage and suction
nozzles of the tub will remain closed
when the hydromassage is off; press
the button (B) to start the pump
and immediately open the suction
nozzle. The hydromassage nozzles
will open after a few seconds.
The tub is fitted with an electronic
sensor which prevents the pump
from starting if the water level is
too low. If, when you press but-
ton (B), the pump does not
and you hear a long beep (or,
in some models, the light flash-
es), you will need to add water
and press the button again.
The pump will also stops if the water
level drops suddenly, e.g. when
you step out of the tub. In all cases,
the hydromassage can be started
again by pressing the start button
after solving the problem (power
blackout, low water level, etc.).
Summary of Contents for hydromassage
Page 26: ...26 Thenewshape ofwell being ...
