44
Troubleshooting
- check that the master switch on the power line is on.
- if, when you try to start the hydromassage, you hear a beep
(in some models the light also
flashes)
, this means that the water level in the tub is too low: see the relevant section.
Tub area
- check that there is no blackout.
- the hydromassage time is preset by default for approximately 20 minutes and therefore
stops automatically after this time. Simple press the start button again.
- if, when you try to start the hydromassage, you hear a beep
(in some models the light also
flashes)
, this means that the water level in the tub is too low: see the relevant section.
The hydromassage does not start
The hydromassage stops by itself
W
e always recommend carefully reading the manual; in the instance that there is an issue,
refer to the following guide.
- check that the nozzles are open.
- set the air adjustment knobs.
- clean the suction nozzle(s) as shown in the “Maintenance” chapter.
Clean the hydromassage nozzles as shown in the “Maintenance” chapter.
- unscrew the hand shower from the flexible hose and check that filter is clean and free
from lime scale.
Few air bubbles come
from the largest nozzles
The pressure from the
hand shower is too low
Summary of Contents for hydromassage
Page 26: ...26 Thenewshape ofwell being ...