J-100
10.2 Activate Jet Pumps
The control panel JETS 1 button activates jets pump 1. The first press
activates low speed, the second press activates high speed, and the third
press shuts jets pump 1 off. The JETS 2 button activates jets pump 2 (if
equipped). The first press activates high speed, the second press turns
jets pump 2 off. When manually activated, either pump will automatically
turn off after 20 minutes.
10.3 Multi-Colored LED Light System Operation
The multi-colored LED light system offers seven constant color
variations and three unique random modes for enhanced spa
enjoyment. Press the Light button once to activate the first
light mode Random Fade, then continue pressing the button
to either turn the light off or to select one of seven constant colors,
random solid color mode or strobe mode as illustrated below.
Spa Light Sequence
DARK
GREEN
DARK
BLUE
RED
LIME
GREEN
OFF
RANDOM
FADE
RANDOM
SOLID
STROBE
OFF
OFF
OFF
OFF
OFF
OFF
OFF
NEAR
WHITE
VIOLET
LIGHT
BLUE
Light Operation Tips:
You must press the light button within 3 seconds of any “off” condition
or the light sequence will revert back to “Random Fade” mode, when
reactivated. Anytime the spa light is manually activated, it will remain on
for 1 hour then automatically shut off.
10.4 Adjusting Individual Jet Flow
The water flow through certain jets in your spa can be
adjusted or turned off by rotating the outside jet ring. Other
jets also offer an adjustable center nozzle that allows
you to change the water discharge angle. Simply tilt the
center nozzle in these jets to the desired angle to customize
your personal massage.
Note:
Always keep at least 6 adjustable jets open at all
times to ensure proper filtration characteristics within
spa.
10.6 Air Controls
Certain jet systems have their own air control (if equipped).
Each control introduces air into the water lines that supply
that specific jet group. Simply turn the air control of choice
counterclockwise to open or clockwise to close.
Note:
To minimize heat loss, all air controls should be closed when the
spa is not in use. Certain jets may not draw air when jets pump 1 is
running in low speed; this is considered normal.
Classic Whirl Jet
Classic Luxury Jet
25