J-100
14.8 Panel Displays blb
If the “bulb” (blb) error should appear on the LED screen,
follow the steps below to deactivate it. This message in
associated with a UV system that requires a UV bulb replacement.
To clear the “blb” message:
1. Press and hold the
Jets pump 1
(
1
) and
Cooler
(
) button
at
the
same time
for 3 seconds to enter the sanitizing system program.
2. The screen will display one of the two menus below:
CLEAR
RAY
Menu
O3 Menu
3. If the LED screen is displaying “
” then pressing the Jets pump
1 (
1
) will change the sanitizing system from “
” to “
”
and exit the programming menu.
4. Press either the
or
to change the display to
. By
selecting this you will disable the countdown timer that creates the
“blb” message.
15.0 Troubleshooting Procedures
In the event your Jacuzzi spa is not working the way it should, please
first review all the installation and operating instructions in this manual
and check the message on the panel display. If you are still not satisfied
it is working properly, please follow the appropriate troubleshooting
instructions below.
Note:
If any of the supply cords to the accessories are damaged,
they must be replaced by authorized service personnel. Contact your
authorized Jacuzzi dealer or qualified service technician.
Always insist
on genuine Jacuzzi replacement parts.
15.1 None of the Components Operate (e.g. Pump, Light)
Check the following:
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Contact your authorized Jacuzzi dealer or qualified service
technician.
Press
or
Press
or
36
