J-200 Series
lock modes (l1-l2)
l1
Lock Out (disables all spa functions to permit filter
cleaning)
l2
Lock Mode (disables the jets and light buttons to
prevent unauthorized use of spa). Filtration/heating
cycle will continue to operate as programmed in
this mode. The tempe
rature display flashes when this function is
enabled. Example: the “F3” filtration/heating cycle was enabled
prior to choosing lock mode. The spa continues to perform the
“F3” cycle until lock mode is canceled, allowi
ng another cycle to be
selected.
To set a ti
me for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire your
first filtration/heating cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM.
note:
Start time is approximate and may vary slightly from day to day.
11.7
Filtration modes for spas with Circulation pump option
(J-230, J-270 and J-280 only)
If your spa is not equipped with the circulation pump option, disregard
this section and refer to page
for filter cycle programming details.
standard Filtration/heating Modes (F0-F3)
(Heater automatically turns on during any heat call while in any Standard
mode).
F0
5 minutes of filtration per day (one 5 minute “Blow-Out”
cycle every 24 hours to purge all plumbing lines)
F1
1 hour of filtration per day (one 30-minute cycle every
twelve hours);
this is the factory default setting.
F2
1.5 hours of filtration per day (one 30-minute cycle
every eight hours).
F3
2 hours of filtration per day (one 30-minute cycle every
six hours
).
economy Filtration/heating Modes (F4-F6)
(Heater can only turn on during an active filter cycle while in any
economy mode).
F4
1 hour of filtration/heating per day (one 30-minute
cycle every twelve hours).
F5
1.5 hours of filtration/heating per day (one 30-minute
cycle every eight hours).
F6
2 hours of filtration/heating per day (one 30-minute
cycle eve
ry six hours).
30
