Page 43
J-400 Series
13.0 spa maintenance
Proper and regular maintenance of your spa will help it retain its beauty
and performance. Your authorized Jacuzzi dealer can supply you with
all the information, supplies, and accessory products you will need to
accomplish this.
DanGer: rIsK OF seVere InJurY Or DrOwnInG BY
enTraPmenT!
Keep hair, loose articles of clothing or hanging jewelry away from
•
suction fittings, rotating jets or other moving components to avoid
entrapment that could lead to drowning or severe injury.
Never use the spa unless all suction guards, filter, filter lid, or skim
-
•
mer assembly are installed to prevent body and/or hair entrapment.
Never operate or use the spa if the filter, filter lid, or skimmer assem
-
•
bly are broken or any part of the skimmer assembly is missing.
Please contact your dealer or nearest service center for service.
The suction fittings and suction covers in this spa are sized to match
•
the specific water flow created by the pump(s). If it is necessary to
replace the suction fittings, suction covers or pump(s), be sure that
the flow rates are compatible and are in compliance with the VGB
Safety Act page
Never replace a suction fitting or suction cover with one rated less
•
than the flow rate marked on the original suction fitting. Using
improper suction fittings or suction covers can create a body or hair
suction entrapment hazard that may lead to drowning or severe
injury.
Owners must alert all spa users to the potential risk of Hair, Limb,
•
Body, Evisceration (disembowelment), and Mechanical Entrapment,
!
13.1
Cleaning the Filter Cartridges
A programmable “Change Filter” reminder icon flashes on the control
panel display after a specified number days to remind you to clean the
skimmer filter and to check the polishing bag filter. This reminder must
be reset at each filter cleanin
g
interval. Refer to section 12.7 (
for additional information and programming details.
Your new spa is
equipped with an advanced 2-stage filtration system. Fine debris are
filtered by the circulation pump drawing water through the ProClear™
skimmer and pleated filter cartridge 24 hours (unless programmed
otherwise). Large debris are filtered when either jets pump is running
when the spa is in use or during a programmed filter cycle. These pumps
draw water from footwell suction fitting and through a secondary water
polishing bag filter. The exclusive footwell “sweeper” suction fitting
enhances filtration in the footwell area by creating a “swirling” water
motion to maximize particle agitation and pickup.