Page 61
J-400 Series
12.
Open/Close Front Panel
Press firmly on the release button (15), then open front panel (16) by
gently lifting upward on bottom edge. To close front panel, gently flip
panel down, then press firmly on panel directly above release button
(15) until you hear an audible “click”. Keep front panel closed at all
the times to prevent water intrusion, except when changing discs.
CauTIOn:
Never insert wet discs into unit or CD player will be
damage!
20.3
J-1000™ audio system radio Operation
1.
radio Operation.
Press MODE button (4) to select Radio mode. Station frequency is
indicated on display.
To Select Band: Press BAND button (8) repeatedly to scroll through
•
radio mode as follows: FM1 --> FM2 --> FM3 --> AM1 --> AM2
-->FM1. Each radio band stores up to 6 independent stations, for a
total of 18 FM and 12 AM presets.
To Program Station Presets in Radio mode: Press and hold SH
•
button (9) until display reads “SHIFT”. Immediately afterwards, press
and hold the Tun
e up/down button (2) for 2 seconds, then repeatedly
press
to select preset 1 to 6. At desired preset, press the ENT button
(9) to store current frequency into selected preset.
note:
When power to spa is shut off for any reason, all station presets
are reset.
2.
automatically setting station Presets
Press and hold the AS/PS button (6) for approximately 2 seconds
until you hear a beep that confirms the memory function is engaged.
The unit will search for six strong stations and automatically store
them on the current band. All 18 FM and 12 AM presets can be set
sequentially by selecting the next band and continuing the operation
during auto programming.
3.
seek/manual Tune
Press TUN up/down button (2) once to activate manual tuning
mode, then press TUN up or down repeatedly to manually increase
or decrease displayed frequency. Press and hold either TUN up or
down button (2) for at least 2 seconds to activate auto tuning mode.
The unit will automatically search and stop at the next higher or
lower station with sufficient signal strength.
4.
Preset scan Function
Press AS/PS button (6) once to enter scan mode. Each preset
station in the current band will play for 5 seconds while the preset
number is flashes on the display (17). At the desired station, press
AS/PS button (6) a second time.
