Page 69
J-400 Series
To drain your spa, perform the following steps:
1. Turn off power to spa at breaker.
2. Locate the drain valve located on the front left
corner on the black plastic pan. Hold the
larger (rear) drain valve body to prevent it
from turning, then loosen and remove the
front cap to expose the underlying male hose
threads.
3. Attach a garden hose to the exposed threads.
4. Gently rotate the larger (rear) valve body
1/3 turn counterclockwise to unlock the drain
valve.
5.
Pull the larger (rear) body outward as shown
to open drain.
6. After the spa drains, perform steps 2-5 in
reverse order to close the drain prior to refilling
spa.
After refilling, turn on power to the spa and follow the steps listed under
“Spa Fill Up Procedures.” (page
). Always fill your spa through both
filter buckets.
14.3 Cleaning the spa Interior
To preserve the sheen of your spa’s surface, it is crucial that you avoid
using abrasive cleaners or cleaners which have adverse chemical effect
on the surface. If you are not certain as to the suitability of a particular
cleanser, consult your authorized Jacuzzi dealer. Regardless of the
cleanser used, use extreme care to assure that no soap residue is left on
the surface. This could cause severe sudsing when the spa is refilled.
14.4 Pillow Care
Clean the four headrests in your spa as needed by wiping them with a
cloth with soapy water. It is not necessary to remove the headrests for
cleaning. To remove headrests for long term storage or replacement,
grasp both ends of each headrest and gently pull inward towards the
center of the spa. To reinstall, over mounting strip and press down until
headrest mounting bracket emits a “click” sound. Then adjust headrest
height by simply moving up or down as desired.
14.5 maintaining the synthetic Cabinet
The synthetic cabinet requires little or no maintenance of any kind. To
clean, simply wipe cabinet
with mild detergent soap solution and a clean
towel.
2.
3.
4.
Unlock
Drain
Open Drain
5.
